Pumping station for water is a device for automated feeding and distribution of liquid to points of consumption. It consists of the key components:.

Surface pump;.

Accumulator;.

Control automatics;.

Manometer.

As a rule, water pumping stations are installed in the pit at a well or in a basement building. The surface on which the device stands should be level and without inclines, and the installation site itself must be protected from moisture and dampness, as this can lead to corrosion of the metal or to the disruption of the operation of electronic automation.

For the uninterrupted operation of the equipment, it is necessary to perform the following steps:.

At the first start of the station in the pump, which is installed on the tank, pour water into the special hole;.

Check the integrity of the suction hose from the borehole, as well as the pipeline that is put into the house, so that there is no air blockage or water leakage, resulting in a loss of pressure;.

Check the tightness of all connections, the absence of bends along the entire length of the suction pipe or the constrictions that have arisen due to installation;.

Provide fluid access from a well or other source for a water inlet hose so that the water supply station does not work "in a dry". For this, it is worth remembering that the suction depth should not exceed eight meters from the surface.

It often happens that the pump station does not shut down or runs continuously. Probably, the reason for this may be improper adjustment of the pressure switch (automatic), which is responsible for turning the pump on / off as the hydraulic accumulator fills up. When the station is released to the relay, factory default parameters have already been set, however, they may become confused during transportation or during operation, therefore it is recommended to revise the equipment once every six months.

If your station starts to turn on and off very often, the reason for this may be a leaking membrane inside the tank, then it must be replaced and the cause will be eliminated. In addition, a breach of the tightness of the steel tank due to cracks or rotting the body can lead to a loss of pressure, which also causes frequent on / off cycles.

We hope that our small tips will help you understand the work of the pumping station, and also are ready to offer you a wide range of goods from the company "Well", which you can order on our website or purchase from the warehouse.